Cube Rotate

[drholzParticipant]

Hello,
Trying out the classic cube rotate with time.delta time.
In the below screenshot, I’m just using the rotate right now.
As I’m rotating about the X axis, I was curious about the inputs options for the X box and the Angle box.
It seems that I can put anything in X (1-1000) and the speed depends on what I put in the angle box.
So what is the X box for?
Also in adding a time.deltatime node, all I could find was ‘get’ or ‘set’.
You already mentioned not to use the fixed, but for ‘set’, (which I think I need?),
all I could find was ‘max time.deltatime’.
There was a regular time.deltatime for get, however.
Sorry for the confusion…

[skreamzParticipant]

as far as i understand, the angle is the amount of rotation, axis is what axis to apply the angle of rotation to. e.g if x = 1 y = 0 z = 0, it would apply the angle to x rotation only, if x = 1 y = 1 z = it would apply angle to x and y rotation.

[drholzParticipant]

In that case, the axis value would just be an on or off value of 1 or 0?
Any other number entered would just be interpreted as a value for that axis.
That would make sense as I can enter 100 or 1 in the X input and it spins the same speed until
I increase the angle input amount.
Now…just need to figure out where that set ‘time.delta time’ node is hiding…
I found a set ‘time.set maximum delta time’ node and it hooks up, but don’t really notice any change
when I input a value on that…
Thanks for your help.

[andygfxParticipant]

Hi,

in download section is SpaceInvaders example. On ship movement I have used timer for movement.

Andy.

[drholzParticipant]

Thank you for the reference Andy.

[Author]

Posts